Traffic Paint Drying Time Wheel
Article No. 11328
Traffic Paint Drying Time Wheel w/Ramp
The Traffic Paint Drying Time Wheel is used in test method ASTM D711, that covers a laboratory test for estimating the drying period required, after application of traffic or pavement-marking paint, for no-pick-up by the tire of an automobile.
Features
- The "O" rings will retain their flexibility indefinitely
- The apparatus consists of a cylinder with two 3/8" cross section diameter “O” rings made of a synthetic rubber meeting the requirements of HK 715 Specification D2000.
- Total weight of the tester including “O” rings is 11 pounds 14 ounces (± 1 oz) (5386 g, ±28 g), which is equivalent to tire pressure of 100 pounds per square inch on the pavement
- The rolling ramp furnished is made of aluminum with a 1:6 slope measuring 6" long, 3-1/2" wide and 1" high at the upper slotted end
- The end to end spliced rings are easily replaced by simply rolling along the cylinder until positioned in the grooves.
- Meets ASTM D711
Standards
Meets ASTM D-711
Procedure
- At regular intervals remove the wheel from ramp and free roll it down the incline over the paint film.
- Position the panel for every run so that a clean surface comes in contact with the rings.
- Clean wheel with solvent at intervals.
- Note point for no pick-up time. See ASTM D711 for details.
Delivery Content
11328 - Traffic Paint Drying Time Wheel, complete with two “O” rings and ramp
Accessories
11361
Set of two special rubber "O" rings
$89.00